Second best was Erixon 565, which had been almost on my MP53 degree. Topped Hot Metallic, 900 cast and AP2 by considerably. Would you simply trust and go with what you have been installed - or try the lighter bend 5.0 edition?Īny experiences with this LZ base in regards of bend?īy the method - the MMC werde by much the best head for me. On top I realized that there can be a 5 - bend with 110 g, which wasn'testosterone levels available during the fitting. The Project X LZ steel takes a chapter out of the book from the original LZ graphite. The Project X LZ Steel shafts come in four different flexes and weights: 5.0 (R flex) at 110gr, 5.5 (R+ flex) at 115gr, 6.0 (S flex) at 120gr, and 6.5 (S+ flex) at 125gr. I recognized that 5.5 is definitely a Regular+ or firm bend and with my club head acceleration of 76 mph with 6 iron, this could be a little bit too much relating to theory. The Project X LZ Steel shafts were tested and reviewed and so far we love what we see. Afterwards at home I go through, that several people purchase the project X shafts with a incorrect, too tough flex. So I will end up being going from Nippon 950 to PX LZ 5.5. The beliefs club head speed, basketball velocity + distribution have been best by significantly with this base and head likened to Nippon Modus 105 L, KBS Visit 90 L and my own Nippon 950 R with MP 53 (which had been fitted end 2010). Proceeded to go through an demanding fitting last night and finally finished up with MP18 MMC and Task X LZ 5.5, which
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |